A good competition suit is an investment in performance. Whether you swim in a competition swimsuit or Race jammer : proper maintenance determines how long your suit retains its compression, fit, and speed. These tips will keep your tech suit in top shape—training after training, race after race.
1. Always rinse immediately after use
After every race or training session, chlorine, sweat and dirt remain in the fabric. Rinse your competition suit that's why with cold or lukewarm water off as soon as you get out of the bath.
- Usage no washing machine or spin dryer – this affects the fabric and seams.
- If necessary, use a mild hand washing detergent such as Hey Microwash .
- Rinse until all the chlorine is gone.
- Don't leave the suit in your bag: moisture and chlorine quickly break down the fibers.
2. Never wring, dry or heat
A The competition suit should never be wrung out or dried in a dryer. Heat and friction break the elastic fibers.
- Gently squeeze out the water with your hands.
- Let it air dry in a warm, well ventilated area .
- Do not place in direct sunlight, on a heater or in the dryer.
This way your suit retains its original fit and compression.
3. Store your suit properly
- Wait to store the suit until it is completely dry.
- Fold it neatly or store it flat in a soft bag.
- Avoid sharp folds, clamps and damp areas.
- Don't leave the suit in your gym bag or car.
4. Put on your competition suit with care
Competition suits are extremely tight and sensitive to pulling forces.
- Make sure you nails short are or wear thin gloves.
- Put on the suit slowly, piece by piece.
- Avoid jewelry, rings or sharp edges.
- Don't pull on one side of the fabric — distribute the pressure evenly.
5. Be careful with rough surfaces
The outer fabric of a competition swimsuit or match pity is vulnerable to abrasion.
- Do not stand on rough benches or tile edges to sit.
- Always use a towel as a base or draw a loose sports pants on while waiting.
- Do not roll over the lines in the pool.
This prevents micro-damage that reduces compression.
6. Alternate between competition and training suits
Use your tech suit only for competitions or short test training sessions. For daily training, a chlorine resistant training swimsuit or Shame better suited.
This way your competition suit will remain strong and elastic for longer.
7. Check the condition of your suit regularly
Every few weeks, check in with:
- loose seams or damaged panels
- fabric that becomes thin at the hips or shoulders
- loss of compression or elasticity
If you see any wear and tear, stop using the suit in competitions – this will prevent tearing during starts or turns.
Frequently Asked Questions – Competition Suit Maintenance
Can a competition suit be washed in the washing machine?
No. Competition suits are allowed. exclusively by hand be rinsed in cold or lukewarm water.
How do I dry my competition swimsuit or jammer?
Let it Air dry , do not wring and do not place on a heat source.
Can I just use detergent?
No. Use only a mild hand wash detergent such as Hey Microwash . Regular detergents damage the coating.
What do I do after a long day of competition?
Rinse the suit immediately and hang it up to dry. Don't leave it in your bag.
How do I prevent damage when tightening?
Short nails, no jewelry, and tighten the hair slowly, segment by segment. Wear plastic gloves if necessary.
Summary
Rinse your competition suit after each use with cold water, use a mild hand wash detergent and let it sit air dry .
Avoid heat, wringing and rough surfaces, put the suit on carefully and do not store it until it is completely dry.
With these guidelines you will stay competition suit , competition swimsuit or match pity Stay in top condition for longer — ready for maximum performance every time you start.
